to turn OFF. This will extinguish the pilot.
While cooling, the ceramic fuel effect may make some crackling noises. This is quite
normal.
If the flames go out while setting the control, repeat the full lighting procedure.
If the flames repeatedly go out have the fire serviced.
Please note. When first turned on the flames will appear predominantly blue. The
ceramic fuel effect will take time to warm up. Although some glow will be seen
after approximately ten minutes, the full visual effect will only be apparent after a
somewhat longer time.
The appliance will operate to its maximum potential if the flue is primed during the
first 20 – 30 minutes of operation. To do this, simply turn the control knob to its
‘HIGH’ setting. This will also burn off any carbon deposits that may have formed
during previous operations.
If operating the appliance for long periods it is beneficial occasionally to change
the settings. This will also help to remove any carbon deposits that may form
during operation.
Lighting with a taper.
See figure 4.
In the unlikely event of failure of the ignition
spark, the pilot can be lit by a taper or long spill.
Insert the taper or spill between the second and
third left hand ceramic fuel effect pieces on the
first row. Operate the control knob as described in
the section headed ‘To light the fire’.
Page 35
© Baxi Heating U.K. Limited 2009.
Figure 4. Lighting with a taper
(The fuel effect may differ from
that shown)
OWNER GUIDE
