4.0 Operating the Fire
6
The fire is controlled by three switches situated on
the upper left hand side of the fire surround. The
illumination effect operates independently to the
High & Low gas rates on the fire.
4.1
To operate the illumination effect
(Fig. 3)
1. To switch on the illumination, press the
button once. The green indicator will come on to
confirm this.
2. To switch off the illumination, press the
button once.
4.2
To light the fire
(Fig. 3)
1. The fire has three settings:-
OFF
LOW
HIGH
2. The ON button has a safety feature built in. It
should be pressed and held for 3-4 seconds. (The
green power ON indicator comes on when the
ON/OFF button is pressed.)
3. During the ignition sequence you will hear an
audible signal. This lasts for up to 20 seconds.
The fire will then automatically ignite on the low
setting.
NOTE:
If the ON/OFF button is pressed and
held for less than 3 seconds the fire will not
ignite. This is a built in safety feature.
4. If the fire fails to ignite or goes out at any time,
switch the fire off and repeat the procedure.
5. If you require the fire on the high setting, press
the High/Low button. The green high setting
indicator will come on to confirm this. This
operation can be undertaken during the ignition
sequence.
NOTE:
It is recommended that the fire is
operated on HIGH initially.
6. To change the fire from high to low, press the
High/Low button once. The green high setting
indicator will go out to confirm this.
NOTE:
When your Bermuda Inset 3 Super is first
used it is possible some smells may be emitted.
These smells will quickly clear with use.
4.3
To turn the fire off
(Fig. 3)
1. Pressing the ON/OFF button once will turn the
fire off and the green power ON indicator will go
out to confirm this.
Fig. 3
Controls & Bezel
ON/OFF
Button
HIGH/LOW
Button
Illumination
Button
Green
Illumination
ON Indicator
Green Power
ON Indicator
Green
High Setting
Indicator
Summary of Contents for Bermuda Inset 3 BB Super
Page 10: ...8 0 Notes 10 ...
