11
6. Slacken the screws at the sides of the
connectors and insert each wire into the
top at either side of the connector, then
re-tighten the screws
7. Make sure the wires are as flat as possible
against the back plate so that they do not
interfere with the controller when it is
mounted in position
8. Press the room unit onto the backplate until
it clicks into place
9. Connect the other end of the wires
to the
R-BUS
terminals in the gateway
(there is no polarity - either wire can be
connected to either position)
10.
The connection between the room
unit and gateway is low voltage,
230V will damage the room unit
and gateway!
