Installing the ATMSpeed/155 Modules
893-01047-B
2-5
5.
Seat the backplane connectors by simultaneously rotating the inserter/
extractor levers inward toward the center of the switch module front
panel to the horizontal position (
Figure 2-5
).
Figure 2-5.
Seating the Module
When the front panel of the module is flush with the front of the chassis, the
module backplane connectors are properly seated.
6.
Use the flat-tip screwdriver to tighten the captive retaining screws at both
ends of the module front panel.
Installing or Replacing the Media Dependent Adapter
The following section provides information about:
•
Installing any of the MDAs on a ATMSpeed/155 MDA and ATMSpeed/155
MDA MCP switch modules
•
Replacing an MDA on an MDA switch module
•
Connecting UTP cables to the MDA
•
Connecting fiber optic cables to the MDA
•
Connecting coaxial cable to the MDA
Note:
The captive retaining screws on the module must be tightened to at
least 2 inch-pounds, but no more than 4 inch-pounds, of torque. Finger
tightening is also adequate. Do not overtighten.
6537FA
Summary of Contents for Centillion 100
