am.book : ch8 6 Tue May 6 13:24:47 1997
Annex Manager User Guide
Chapter 8 Setting WAN Module Values
8-6
Part 2 Setup Mode
Switch Type
is not available on 5391 and 6100 Annexes. The
Switch
Type
is automatically set to
US_T1
.
The
Edit WAN Module
window selects the
Default
and
Other
buttons based on
current
Switch Type
settings:
•
Default
displays as selected if the switch type is not set when
you first use the
Edit WAN Module
window
. If you do not choose
another setting, the Annex you selected uses
AT&T5ESS
for T1
and
ETS
for E1.
•
Other
displays as selected if the switch type is not in the Switch
Type list. You can use admin CLI commands to check these
values.
•
Buildout
allows adjustment of the cable loss measurement
between the last T1 signal regenerator and your location. This
measurement is supplied by the telephone company at
installation. You need to adjust your buildout based on this
measurement. There are four choices:
–
0 dB
–
7.5 dB
–
15 dB
–
22.5 dB
•
FDL Type
allows you to configure the FDL standard. It describes
the facilities data link use. This allows the telephone company
to read the statistics maintained by an Annex and to perform
diagnostic tests. There are two choices:
•
ATT
for ATT-54016 ESF FDL
•
ANSI
for ANSI-T1-403 FDL
•
Framing
selects the superframe format used on the T1 Network
interface. Your selection must match the format supplied by the
telephone company. There are two choices:
–
ESF
–
D4
Summary of Contents for Manager
Page 10: ...am book amTOC doc x Tue May 6 13 24 47 1997 Annex Manager User Guide Contents x ...
Page 14: ...am book amLOF doc xx Tue May 6 13 24 47 1997 Annex Manager User Guide Figures xx ...
Page 16: ...am book amLOT doc xxii Tue May 6 13 24 47 1997 Annex Manager User Guide Tables xxii ...
Page 22: ...am book pref xxviii Tue May 6 13 24 47 1997 Annex Manager User Guide Preface xxviii ...