am.book : ch14 9 Tue May 6 13:24:47 1997
14-9
Chapter 14 Using the AppleTalk, IP, IPX, and LAT Windows
Annex Manager User Guide
Part 2 Setup Mode
Understanding the LAT Window
The
LAT
window uses the following fields:
•
Server Name
identifies the Annex in the LAT protocol. The
name you enter should match the VMS host's node name used
in the HIC configuration file. The default value is
LAT
followed
by the physical ethernet address of the server (e.g.,
LAT_080002BF0020
).
•
Remote Group Codes
specifies LAT protocol remote group codes
that can access local services offered by an Annex. To access
these services, the Annex must have at least one enabled group
code that matches the service's group codes. You can enter
all
,
none
, a series of numbers separated by commas, (e.g., 1, 5, 7) or
a range of numbers separated by dashes (e.g. 1, 5, 200-255).
You can use any number between 0 and 255.
•
Virtual CLI Group Codes
specifies remote group codes that are
assigned to virtual CLI users. All virtual CLI users have the
same group code. You can enter
all
to enable all groups,
none
to
disable all groups, a series of numbers separated by commas
(e.g., 1, 5, 7), or a range of numbers separated by dashes (e.g. 1,
5, 200-255). You can use any number between 0 and 255.
Summary of Contents for Manager
Page 10: ...am book amTOC doc x Tue May 6 13 24 47 1997 Annex Manager User Guide Contents x ...
Page 14: ...am book amLOF doc xx Tue May 6 13 24 47 1997 Annex Manager User Guide Figures xx ...
Page 16: ...am book amLOT doc xxii Tue May 6 13 24 47 1997 Annex Manager User Guide Tables xxii ...
Page 22: ...am book pref xxviii Tue May 6 13 24 47 1997 Annex Manager User Guide Preface xxviii ...