am.book : ch22 57 Tue May 6 13:24:47 1997
22-57
Chapter 22 Annex Parameters
Annex Manager User Guide
Part 5 Reference Information
load_dump_sequence
specifies available network interfaces and the order in which they are used for a
down-line load or an up-line dump. You can list more than one interface by using
commas to separate interface names. You can enter:
•
net
to specify a local area network.
•
sl + port number
(e.g.,
sl2
) to specify a SLIP line. If you enter
sl
and a port number, you must enter an address in the
slip_load_dump_host
parameter.
•
self
to instruct an Annex to boot its image from the Flash
ROMs. Since the Annex cannot dump back to itself, you should
include a secondary interface here by entering
self, net
or
self,sl+port number.
local_address
defines the IP address for the port on the Annex side of the link. This IP address
is used only when
mode
is set to
slip
,
ppp,
or
autodetect
.
location
defines a port location or description that displays at the CLI
who
command.
lock_enable
allows any port to use the LOCK DECServer command.
Type
Annex
Value
net, sl+ port number, self
Default
net
Lists
Annex Only, Basic Annex
Type
Async
Values
IP address
Default
0.0.0.0
Lists
Async Port, PPP, SLIP
Type
Async
Values
0 to 16 characters
Default
“ “ (null string)
Lists
Async Port, Basic Async Port
Type
Annex
Values
enabled or disabled
Default
disabled
Lists
Annex Only, Security
Summary of Contents for Manager
Page 10: ...am book amTOC doc x Tue May 6 13 24 47 1997 Annex Manager User Guide Contents x ...
Page 14: ...am book amLOF doc xx Tue May 6 13 24 47 1997 Annex Manager User Guide Figures xx ...
Page 16: ...am book amLOT doc xxii Tue May 6 13 24 47 1997 Annex Manager User Guide Tables xxii ...
Page 22: ...am book pref xxviii Tue May 6 13 24 47 1997 Annex Manager User Guide Preface xxviii ...