am.book : ch22 91 Tue May 6 13:24:47 1997
22-91
Chapter 22 Annex Parameters
Annex Manager User Guide
Part 5 Reference Information
short
_break
allows an Annex to return a user to the CLI prompt after receiving a break of
less than two seconds.
slip_allow_dump
enables an Annex to dump its operational code across a SLIP link.
slip_load_dump_host
contains the IP address of the host from which an Annex receives a load or to
which it sends dumps over the SLIP interface. If you entered
sl
and a number in
load_dump_sequence
, you must enter a valid address here. This parameter
value overrides values in
pref_load_addr
and
pref_dump_addr
.
slip_mtu_size
sets the maximum transmission unit (MTU) size on a SLIP/CSLIP port. This
parameter forces the SLIP interface to use large (1006) or small (256) MTUs.
Type
Async
Values
enabled or disabled
Default
disabled
Lists
Async Port, Idle Timer
Type
Async Port
Values
enabled or disabled
Default
enabled
Lists
Async Port, SLIP
Type
Async
Values
IP address
Default
0.0.0.0
Lists
Async Port, SLIP
Type
Async
Values
large or small
Default
small
Lists
Async Port, SLIP
Summary of Contents for Manager
Page 10: ...am book amTOC doc x Tue May 6 13 24 47 1997 Annex Manager User Guide Contents x ...
Page 14: ...am book amLOF doc xx Tue May 6 13 24 47 1997 Annex Manager User Guide Figures xx ...
Page 16: ...am book amLOT doc xxii Tue May 6 13 24 47 1997 Annex Manager User Guide Tables xxii ...
Page 22: ...am book pref xxviii Tue May 6 13 24 47 1997 Annex Manager User Guide Preface xxviii ...