37
Tickets on
monitor does
not
match
tickets coming
out of game.
Opto Sensor on ticket
dispenser dirty.
Faulty ticket dispenser.
Notch on tickets cut too
shallow.
Faulty cable. Disconnected,
loose or broken wires.
Enter Diagnostic menu and
test Dispenser
Check dipswitches on I/O
Aux Board
Faulty I/O Aux Board
Blow dust from sensor and clean with
isopropyl alcohol.
Replace with working dispenser to isolate the
problem. (A5TD1)
Flip tickets and load upside-down to have large
cut notch toward opto sensor.
Check connectors from ticket dispensers to I/O
Aux Board. Check for continuity.
Cables CE26011
There are many options that affect ticket payout
using the dipswitches. Refer to Dip Switch
Setting page.
Replace I/O Aux Board. AACB9605-CBL
Tickets on
monitor do
match tickets
coming out of
game.
Settings in Menu are
incorrect.
Propeller Sensor not
working properly.
Enter Menu and check certain areas: Preset
Ticket Pattern & Mercy tickets.
Refer to “Propeller Sensor not working properly”
section.
Tickets do
not dispense
or Wrong
amount
dispensed.
Check for
the correct
amount of
tickets
showing on
Monitor
Low Tickets
message on
monitor
Tickets are empty in ticket tray
Faulty cable. Disconnected,
loose or broken wires.
Faulty low ticket switch.
Faulty I/O Aux Board
Load tickets into tray. Ensure tickets hold down micro
switch wire.
Check connectors from low ticket switch to I/O Aux board.
Check for continuity. (CE23056)
Inspect switch and replace if needed. (AASW200)
Check dipswitches on I/O Board, Replace I/O Aux Board if
needed. AACB9605-CBL
Problem
Probable Cause
Remedy
TROUBLESHOOTING GUIDE
Propeller values
are a bit off target
The top sensor is dirty.
Top Sensor needs
calibration.
Open the side plexi and wipe off the top sensor.
Refer to “How to Fine Tune Propeller Calibration” section.
