10
LIL TICKET MONSTER GAME SETUP
Pull the printed plexi wrap around the front of
the game tightly, with the eyeball light through
the round cutout in the plexi.
Continue wrapping the top of the cabinet and
get ready to insert one screw in this location.
Line up the printed plexi with this pilot hole and
insert 1 of the black screws from the hardware kit
using a #2 square bit screwdriver.
Make sure the bolt hole is centered in the hole of the
printed plexi.
A5SCPH151
Pull the printed plexi snuggly until this bolt is
centered in the hole of the printed plexi.
A5SCPH151
Insert another of the
black screws from the
hardware kit using a #2
square bit screwdriver.
