38
HOW TO ADJUST ARROW SENSOR
The wheel sensor “sees” the notches on the right side of the wheel.
As the game is played, the wheel spins downward and the ticket value
changes as the point of the arrow crosses the dividing line.
If the wheel value changes too early or too late, the sensor must be
adjusted.
Tools Needed:
Phillips Screwdriver
Instructions:
The front plexi must be open, refer to “How to Open the Front Plexi”.
Use a Phillips screwdriver to turn the screw on the bottom of the arrow
assembly.
Clockwise will raise the sensor.
Counter
-
clockwise will lower the sensor.
HOW TO ADJUST BRAKE TENSION
The wheel brake is spring tensioned pad that pushes against the wheel to
slow and stop the wheel after a “good spin speed” has been reached.
Too tight of brake tension will stop the wheel quickly and may allow a
skilled player to master the technique and achieve more bonus wins.
Too loose of brake tension may allow the wheel to rock backwards as it
comes to a stop. If it rocks backward over a notch, the tickets won will be
incorrect.
Instructions:
Remove the back door of the game and set aside.
Use a needle nose pliers tp loosen the nuts on the threaded eye
hook.
Adjust threaded eye hook up
-
to increase tension on wheel brake.
Adjust threaded eye hook down
-
to decrease tension on wheel brake.
To test brake tension: Enter Diagnostic Menu, Wheel Debug Menu.
Enable Engage Wheel and push the handle to spin the wheel fast.
The screen will show “tighten Brake”, “Loosen Brake”, or “Brake OK”
