25
Problem
Probable Cause
Remedy
Game not coining
up.
Check for I/O board USB
cable communication.
Ensure game makes sound
when coin switch is
triggered.
Game set to large amount of
credits per game.
Refer to “I/O Aux Board Issue” diagnostic Section.
Check coin switches—both should be wired normally
open. If one switch is “closed” the other will not work
either. Check wiring to I/O Board. (AACBL4A-DOORA,
AACE8006)
Check Game Setup Menu. Ensure Coins/Credits per
Game is set. Default = 4.
No Sound
Motherboard cre-
ates sound, Audio
board amplifies it.
Volume set to zero in
menu.
Ensure “Mute” is set
to OFF
Disconnected, loose
or broken wires.
Faulty speaker.
Enter Volume & Attract Settings Menu and verify:
Game Volume & Attract Volume is not zero
Check connections and reseat audio cable from motherboard to
Audio Amplifier board to speakers. Cables # AACE8811A,
AACE8001, A5CE2300 and A5CEAU010 to green socket.
Ensure 12 volts at CE8015 cable from power supply.
Unplug audio jack (A5CE2300) from motherboard, plug into
MP3 or phone. Music should be amplified and comes out of
Speaker. If Yes - then motherboard is faulty.
If No - then Audio Amplifier may be faulty.
Replace speaker. AACE8811
Marquee Lights
are not on.
(7 Watt 110/220 VAC)
Faulty Light Bulb
Faulty Cable
Faulty outlet strip
Replace bulb. Part # A5LI0004
(7 Watt LED 110/220 VAC
)
Check for proper
connection from
bulb to Power Strip.
Check
continuity. (AACE19004, AACE19002, A5CORD5000)
Swap power cord into next socket. Replace strip (A5OU5000)
Menu Buttons do
not work.
Swap menu buttons.
Pinched, broken, or
disconnected wiring
Main board faulty.
Replace button if problem stays with button.(AAPB2700)
Inspect crimp to ensure good connection.
Check connections from menu buttons to I/O Aux board.
Check continuity on wires. (AAPB2700, AACE8005)
Replace I/O Board. (AACB9604A)
LED’s around
monitor do not
work.
Faulty Cable
No USB
communication
Faulty LED
Faulty Light Board
Check for proper
connection from
Light Board to LED strips.
Check continuity. (AACE8008, AACE19006)
Refer to “Light Board Wiring Diagram”
Ensure the A5CORD58 is connected to the motherboard USB
socket. Red and yellow LED’s should be on.
Replace LED strip AACE19006
Replace Light board if needed. (AACB8001)
TROUBLESHOOTING GUIDE
LED’s around
star on plunger
do not work.
Faulty Cable
No USB
communication
Faulty LED
Faulty Light Board
Check for proper
connection from
Light Board to LED strips.
(AACE8003, AACE19005)Refer to Light Board Wiring Diagram
Ensure the A5CORD58 is connected to the motherboard USB
socket. Red and yellow LED’s should be on.
Replace LED strip AACE19005
Replace Light board if needed. (AACB8001)
