30
HOW TO REMOVE MONITOR
Tools Needed:
# 2 Square bit screwdriver
Philips Screwdriver bit
7/16” Wrench
2 people
Instructions:
Unplug the game’s power cord from the wall.
Unlock and remove the upper back door of the game,
Remove the 2 screws using a # 2 square bit, and remove the wood
block . Save for later installation.
Unplug the HDMI cable from the monitor.
Carefully snip the plastic zip tie holding HDMI cable
to the monitor.
The HDMI cable can now be left in the rear of the
cabinet.
Unplug the 4 pin square connector which supplies power to the
monitor surround lights.
Unclip the monitor power cable from the plastic wire saddles along the
length of the cable.
Unplug this from the power cable in the bottom rear of the cabinet.
This monitor power cable will come off the cabinet with the monitor
housing.
MINI
Remove the marquee:
In the upper rear of the cabinet:
Remove the 3 bolts using a 7/16” wrench. Save for later installation.
Unplug the AC light bulb power by disconnecting the 2 pin Molex plug.
Carefully lift the marquee from the top of game and set aside for later
installation.
Using 2 people, carefully lift upwards on the monitor housing.
Lift up a few inches to allow the white plastic locking tabs to clear,
then pull away from the cabinet.
Place monitor housing face down on soft surface.
