EN-10
Single Electric 2-Phase Breast Pump
EN
10
■
Breast milk can be stored for up to 48 hours in a refrigerator (except for the door area) and up to 3 months
in a freezer at a temperature of -18 °C .
■
If you express the milk gradually and wish to mix the individual batches together into a single container and
freeze them, do so no later than within 24 hours . It is only possible to mix batches that are cooled to the
same temperature .
■
Mark the containers or bags that you place in the freezer with a date .
Note
The bottle
A
qs
with the seal cap
A
0
can be stored both in the refrigerator and in the freezer .
■
Before this milk is fed to an infant, it should be heated up to a temperature of approx . 37 °C . Frozen milk can
be left overnight to defrost in a refrigerator . Defrosting in a refrigerator must not, however, take longer than
24 hours . Heat the milk gently in a baby bottle warmer or in a container with warm water . Do not use boiling
water as this could destroy the nutrients through high temperatures . Microwave ovens are not particularly
suitable for heating breast milk, namely because of uneven heating .
■
All parts of the bottle from which the milk is fed to the infant must be sterilized before they come into contact
with the breast milk . To assemble the baby bottle that comes with the breast pump, insert the nipple
A
qa
into the bottle opening cap
A
8
and then attach the bottle opening cap
A
8
to the bottle
A
qs
. If you wish
to use a narrow-neck bottle to feed an infant, attach the bottle adaptor
A
9
to the underside of the bottle
opening cap
A
8
and then screw this assembly on to the respective bottle . When necessary, you can use
a different baby bottle with a nipple . Before feeding, always first shake the bottle and check the temperature
of the milk . Dispose of any unused milk that has already been defrosted or heated up .
Troubleshooting
In this chapter you will find possible solutions to problems that you may encounter when using the breast pump .
If you are unable to remedy the problem according to the following instructions, please contact an authorised
service centre .
■
The breast pump does not start when the Power On/Off button
B
qa
is pressed .
–
Check that the pump unit
A
qj
is connected to a working power socket . In the case where an internal
power source is used, check that the batteries were inserted correctly and that they are not flat .
■
Low or no suction intensity
–
Check whether the breast pump is correctly assembled and whether the individual parts are properly
attached to one another . The connections between the individual parts of the breast pump must not
be loose .
–
Weak or almost flat batteries . Even when the battery power level indicator
B
2
is still showing 2
segments, the batteries may be weak and it is necessary to replace them with new ones .
–
Check that the silicon pad
A
2
has properly adhered to the breast . Do not hold the breast pump by the
bottle connector
A
4
. Express milk seated with a straight back . Hold the silicon pad
A
2
on the breast
with your thumb and index finger and support the breast with your palm .
–
Check that the silicon tubing
A
qk
is not twisted and that there is no water inside it . Prior to starting
expressing milk, all components must be dry and the silicon tubing
A
qk
must not be bent . In the event
that there is water inside the silicon tubing
A
qk
, you may use the dry tubing from the replacement
accessories .
