EN
EN-6
Single Electric 2-Phase Breast Pump
EN
7
Assembling and disassembling the breast pump
■
Before you start assembling the breast pump, clean and sterilize the individual parts according to the
instructions contained in the chapter "Cleaning and sterilization" and thoroughly wash your hands .
!
Attention:
Never submerge the pump unit
A
qj
or power adaptor
A
w;
in water or any other liquids or sterilize these
parts because they do not come into contact with the breast milk or the breast .
■
Always assemble the breast pump according to the following instructions . Otherwise the suction intensity
could be lowered .
■
Check that no part of the breast pump is damaged or worn out and that all parts that will be used during the
assembly are dry . Damaged or worn out parts must be replaced for new ones . To order replacement parts,
please contact an authorised service centre .
■
Insert the silicon pad
A
2
into the plastic brace
A
3
and push it in all the way . Push down the edge along
the plastic brace
A
3
with your fingers so that it attaches well .
■
Place the plastic brace
A
3
with the silicon pad
A
2
on to the nozzle, which is located on the front part of
the bottle connector
A
4
. Tilt the plastic brace
A
3
with the silicon pad
A
2
slightly upwards so that the lip
located on the nozzle slides in first . Then carefully push the plastic brace
A
3
on to the bottle connector
A
4
so that these parts are connected .
■
Into the top part of the bottle connector
A
4
, insert the bladder
A
qh
and put the bladder cap
A
qf
on to
it . Turn the bladder cap
A
qf
clockwise to properly connect it to the bottle connector
A
4
. The hole in
the bladder cap
A
qf
for connecting the silicon tubing
A
qk
with tubing connector
A
ql
should point in the
opposite direction to the plastic brace
A
3
with the silicon pad
A
2
. Connect the tubing connector
A
ql
with
the silicon tubing
A
qk
to the hole in the bladder cap
A
qf
.
!
Attention:
There must be no water in the holes of the bladder cap
A
qf
and inside the silicon tubing
A
qk
with tubing
connector
A
ql
.
■
Connect the flap
A
7
to the valve
A
6
so that the semicircular-shaped stub on the underside of the flap
A
7
fits into the hole of the same shape in the valve
A
6
. To ensure that the flap
A
7
properly adheres to the
valve
A
6
, push it down with your thumb .
■
Mount the valve
A
6
with the flap
A
7
into the underside of the bottle connector
A
4
.
■
Screw the bottle
A
qs
on to the underside of the bottle connector
A
4
. Place the bottle
A
qs
into the bottle
stand
A
qd
.
■
Connect the free end of the silicon tubing
A
qk
with the tubing connector
A
ql
to the socket
B
qd
on the right
side of the pump unit
A
qj
.
■
To disassemble the breast pump proceed in the reverse sequence .
