237 • Owner’s Manual
Supplement
Chapter 6: Plumbing
31
Livewell System
Filling & Using the Livewell
1. Insert the standpipe
into the drain fitting at
the bottom of the tank.
2. Open the seacock.
3. On the switch panel,
turn On the livewell
pump (for the location
of the livewell pump
switch, see the Compo-
nent Locations section
in Chapter 2 of this
supplement).
•
Remove the standpipe
to drain the livewell.
Troubleshooting
If you followed the instruc-
tions in steps 1 through 3
above, but water does not
pump into the tank, possi-
ble causes are:
•
The intake seacock is
Closed.
•
A hose is collapsed or
there is clogging debris
in the system.
•
The livewell fuse is
blown.
FLOODING and SWAMPING HAZARD!
•
NEVER leave your boat unattended while the livewell system is running.
•
Any leak or break in this system may allow large amounts of water to flood the bilge, which
could swamp the battery(s), and even sink your boat.
•
Close the intake seacock when leaving your boat unattended for any length of time.
WARNI N G!
!
SYSTEM DAMAGE HAZARD!
BEFORE turning On the livewell system, make sure the intake seacock is Open.
CAUTI ON
!
AERATOR
VALVE
STANDPIPE
ATTACHED
TO THRU-
HULL DRAIN
STANDPIPE
REMOVED
Summary of Contents for 237 Deckboat
