2858 Classic Cruiser • Owner’s Manual Supplement
Chapter 2: Features & Systems
27
Freshwater System
Your boat is equipped with a pressure-type (demand) freshwater
(potable) system. To use this system turn On the water pump switch,
located next to the AC panel (see photo on right).
•
The water pump’s DC breaker must be turned On to use freshwater.
•
The water pump’s DC breaker should be turned Off when either of
the following occurs:
1. When the boat is not in use.
2. Whenever the water tank is empty.
•
The water tank fill fitting is located on the starboard deck, forward
of the louver (see illustration on the right).
•
When your boat is to be left unattended for long periods of time,
pump the water tank dry to prevent stored water from becoming
stagnant and distasteful. Should it become necessary to disinfect
the freshwater system, ask your dealer about treatments available
for your boat’s system.
•
Inspect and clean the water filter, located on the water pump, often.
•
The water tank is located below the salon floor.
WATER TANK
FILL FITTING
WATER TANK
VENT FITTING
TANK
WATER
WATER PUMP AND WATER
TANK ACCESS THROUGH
WALL AND FLOOR CUTOUTS
PUMP
TANK
FWD
WATER LINE ROUTING
FROM WATER TANK
WATER
PUMP
WATER LINE
TO GALLEY
WATER LINE
TO HEAD
FITTING FOR
HEATER
WATER
COLD WATER
FITTING FOR
HOT WATER
LINE
LINE
PUSH TO RESET
CIRCUIT BREAKER
(UNDER METAL COVER)
WATER TANK
FILL FITTING
WATER TANK FILL
LOCATION
PUMP
SWITCH
AC PANEL LOCATED IN STARBOARD CABIN
AC PANEL
12 VOLT
RECEPTACLE
Summary of Contents for 2858 Classic Cruiser
