Chapter 2: Features & Systems
2858 Classic Cruiser • Owner’s Manual Supplement
32
Marine Head with Holding Tank
Your boat comes equipped with a marine head (toilet) and waste holding tank system. Be sure to read the
manufacturer’s operation and maintenance manual (included in your boat’s owner’s packet).
•
The marine head installed on your boat uses seawater to flush waste from the toilet. The seawater intake valve
(seacock) is located in the engine compartment.
•
Waste is routed directly from the head to the holding tank.
•
The holding tank is plumbed to a fitting on the deck for dockside pump-out.
•
You can determine the content level of the holding tank by looking at the tank located under the forward floor
hatch in the main cabin. We advise emptying the holding tank at every opportunity.
•
If you are unable to pump water into the bowl, the probable cause is debris in the pump diaphragm. To remedy
this, shut Off the seawater intake valve (seacock) and dismantle the pump. The pump is generally held together
with six screws (the design is simple and the problem will be obvious when the pump body is split Open).
NOTI C E
Check with local authorities for regulations regarding the legal use of marine head systems.
HOSE TO
HOSE TO
HOLDING
TANK
MARINE
MARINE
HEAD
HOLDING
TANK
MARINE HEAD SYSTEM
HOSE TO
HEAD PICKUP LOCATED
IN THE ENGINE ROOM
AFT
HOLDING
TANK VENT
HEAD
MARINE
HEAD
PICKUP
HOLDING
FROM TANK TO
OVERBOARD
MACERATOR
MACERATOR
DISCHARGE
SEACOCK
TANK
MACERATOR SYSTEM (OPTION)
AFT
FITTING
PUMP OUT
WASTE
Summary of Contents for 2858 Classic Cruiser
