Access codes
User code
Service code
1234
5678
9
Electrical connections on the device
As soon as the water values have been set and your unit
with all its components has been installed, you can start
commissioning your Automatic
SALT
.
Switch on your Automatic
SALT
and follow the instructions
on the display. You will be taken through the initial Setup
Wizard, which will help you with the essential settings.
Of course, you can also access all the settings you have
made later and adjust them, if necessary.
As soon as the individual steps have been completed,
the Automatic
SALT
starts operation.
Tap in the blue frame areas to access
the respective context menus.
10
Commissioning
11
Operation
Status icons pH
Operation mode
Indicator dosing pump pH
fill level of canister (red, if empty)
Status icons Electrolysis
Operation mode
Polarity
Cover
Winter
Cover cable (191049 Cable 2.5 m for cover)
Level switch (e.g. 172130 KIT Level Automatic single
Electrolysis cell
Mains supply
(must remain powered continuously)
6
7
8
9
RedoxSensor
USB connection
pHSensor
PaddleFlowSwitch
Temperature Sensor
1
2
3
4
5
IMPORTANT
The controller must be grounded and the mains supply
must be equipped with a residual current protection (30 mA).
33
