4 Operating the Salt Relax POWER
16
NOTE!
Please note that the respective auxiliary relays can only be used if this is enabled in the Service menu!
Unless enabled, the respective relay is classified as used for other purposes (through predefined functions) and the associated menu
items are not displayed in the main menu.
Aux Rel 3 is generally not used for other purposes and is therefore always visible and utilisable.
4.3.4
pH calibration / redox calibration / setpoint
These menu items are only visible and active if the option pH option and/or the redox option is installed.
Please refer to the chapter pH option and/or Redox option for further information.
4.3.5
Temperature calibration
In this menu, the temperature sensor can be calibrated with the displayed temperature value.
If you control your pool heating with the Salt Relax POWER, this calibrated temperature value is used to switch
the heating on and off.
To set, select Temperat. cal. with
/
and confirm with
Manual temperature calibration
Specify the temperature at the temperature sensor (e.g. pool water
temperature).
Set this temperature in the line Target measurement using
/
(Coarse adjustment) or using
/
(Fine adjustment), and confirm
with
.
If you do not wish to calibrate the temperature, press
to exit this menu
item.
4.3.6
Electrolysis
The menu Electrolysis is used to make all settings relating to chlorine production.
The Electrolysis bar displays the set production capacity in %.
To set, select Electrolysis 50% with
/
and confirm with
