2 Content of the packaging
4
Failure to follow the safety instructions may result in danger to persons, the environment and the device itself. Failure to observe the safety
instructions will also lead to the forfeiture of claims for damages and loss of warranty.
The Salt Relax POWER is intended exclusively for use in private swimming pools.
DANGER!
Danger resulting from inadequate qualification of personnel/service technicians/installation technicians. Possible consequences are
serious or even fatal injury and severe damage to material assets. The following conditions therefore apply:
The operator of the plant must ensure that personnel are adequately qualified.
All tasks must be performed exclusively by correspondingly trained personnel.
The system must be protected against access by persons who are not adequately qualified, e.g. by means of access codes and
passwords.
IMPORTANT!
The operator of the plant must ensure compliance with the relevant accident prevention regulations, other legal provisions and the
generally accepted rules of safety engineering!
2
Content of the packaging
1 Salt Relax POWER
2 Temperature sensor
3 Cable grommets
4 Installation material
5 Reducer 75-50 mm
6 Chlorine production cell
(cell and housing)
7 Salt Quicktest
8 Holder for temperature sensor
9 Holder for paddle switch and
pH/redox electrodes (optional)
10 Plugs
11 Paddle switch
3
Installation
NOTE!
Ensure that all components of the pool system which may come into contact with the pool water are resistant to salt water.
In particular, make sure that the filtration pump is resistant to salt water.
Note that even water with a low salt content can be corrosive, and take this into account when selecting components for use
(e.g. steel ladders etc.).
Necessary qualification:
The Salt Relax POWER must be installed by a specialist with both in-depth knowledge of swimming pool construction and in-depth
knowledge of the installation of electrical and electronic devices!
Danger caused by electrical current
The Salt Relax POWER is live as soon as voltage is applied to the power input. The chlorine production cell or additional functions
may be switched on or switched over. Contact with live components can lead to an electric shock.
This may result in serious or even fatal injury and damage to material assets, and the following therefore apply:
All such tasks must be carried out exclusively by adequately trained and experienced personnel!
The device must always be de-energised before performing installation and maintenance work on it!
Secure the device against being switched on while work is being performed on it!
Additional modules must be installed/removed in de-energised state!
Cables must also be connected in de-energised state!
A safety feature which is independent of the device should always be present!
Where necessary, password protection for the main menu must be activated!
The relevant country-specific safety regulations must be complied with!
All safety features and protective devices must be refitted or rendered functional again immediately after completing work!
Failure to follow the safety instructions can cause the device to malfunction, may lead to the risk of fatal injury and renders the
warranty invalid!
