Option Two:
If the source does not have an Auto-Antenna lead (or if the Auto-
Antenna goes down during tape operation),you can connect the
Amplified Bazookas' Remote Turn On Wire to an accessory or igni-
tion point at the vehicle fuse block. In this configuration, the
Amplified Bazooka will be on whenever the ignition is on. This
method may allow noise or turn-on-and-off transients to become
amplified when the source unit is not in use. When you are using
this Option, the Quick Disconnect YELLOW On/Off Jumper Loop
MUST be disconnected from the wiring harness.
Option Three:
The Amplified Bazooka has a built -in Auto Turn-On Feature. If
you choose to use this feature, the Amplified Bazooka will turn on
automatically whenever there is music present at the inputs (high
level or low level input). Please take notice of the Quick Disconnect
Yellow On/Off Jumper Loop located on the Amplified Bazooka
wiring harness. SAS ships the Amplified Bazooka with this Jumper
Loop plugged into the wiring harness. When the JUMPER LOOP
plugged in, the Auto Turn-On Option is in the ON position and the
Amplified Bazooka will turn on automatically when it senses any
music at the inputs. The ORANGE wire
should not be connected
to anything if this feature is being used. Be sure to insulate the
end of the ORANGE wire so that it will not short to ground, as this
may damage the Amplified Bazooka.
TURN ON OPTIONS CONT.
12
The 16 gauge black wire on the 14-pin Molex Mini-fit Jr. connector is
the negative ground wire. It must be connected directly to the vehi-
cle chassis near the amplifier. We do not recommend extending the
ground wire in any installation, as this can cause unwanted ground
loops.
The ground point in the car should be a piece of chassis metal that is
part of or welded to the main body of the vehicle. Painted surfaces
should be scraped or sanded clean to expose the bare metal before
the ground lug is bolted down. (Cover the bare metal area with paint
or grease after you finish mounting the ground wire to prevent rust.)
GROUND WIRE
REMOTE TURN ON OPTIONS
11
The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit
Jr. connector is the Remote Turn On Wire. You have several options
in connecting the Remote Turn On Wire. These options are listed in
the order of preference recommended by SAS. Select the option best
suited for your application.
Option One:
For the most versatility the Remote Turn On Wire should be connect-
ed to the source unit's "Accessory", "Auto-Antenna" or "Remote"
lead -- any of which will supply 12 Volts positive when the source is
turned on. When you are using this configuration, the Quick
Disconnect YELLOW On/Off Jumper Loop MUST be disconnected
from the wiring harness.
