5
ENGLISH
FRANCAIS
SP
ANISH
DEUT
SCH
⑤ INPUT VOLTAGE
IMPORTANT:
Before turning on your amplifier, check that you
have positioned the voltage selector based on your geographic
location: AC110V (USA, etc ...) and AC230V (EU, etc ...). Also be
sure to use a fuse appropriate for the selected voltage sector.
Example position voltage selector:
220V for Europe
110V for USA
fuse T3AL/250V
fuse T6AL/110V
⑥ AC MAIN INPUT
Once all connections to the amplifier, plug the power cable into
an outlet and turn the unit on. Your amplifier is now ready for
use.
⑦ WIRELESS ANTENNA
This connector is for receiving a WIRELESS antenna. The
supplied antenna is mounted directly to the back of the unit. It
is possible to obtain an optional WIRELESS long-range antenna.
⑧ OPTIONAL BOARD POWER
This connector is for receiving the power supply cable of an
external optional board. For connecting the optional Phono
card, for example, we will use the stereo power cable (supplied
with the card) and a stereo RCA cable connecting the card to the
amplifier by one of its line inputs (Line 1 to Line 3).
Connections
Under the amplifier
SWITCH ANTI-HUM (GROUND ON / OFF)
Your amplifier has a mains socket outlet
with a ground connection. The use of
this type of connection is recommended
for electrical safety reasons (including
wetlands). However sometimes this connection «mass» is the
origin of «hum» audible from the speakers in a hi-fi system to
solve this problem, the cancellation of the ground connection
is sometimes sufficient. To do this you have, under the device,
a switch to choose to connect or not the mass of the device to
the mains.
① POWER: ON / OFF BUTTON
This switch allows shutdown or operation of the amplifier.
② IR SENSOR
This window receives IR commands (Infra Red) from the remote
control. It is essential that there is no obstacle between the
remote control and the sensor.
TONE CONTROL AND BALANCE
These functions on music signals output from the speakers and
the line output (RCA) outputs. They are not active on the REC
output (for recording the original signals).
③ BASS and TREBLE
The button «BASS» setting can act on the relative level of low
frequencies to alter the tonal balance of the sound to suit
your room acoustics and your tastes. The «TREBLE» button for
meanwhile high frequencies.
When these buttons are in the middle position, it means that
the tonal balance is not changed. The adjustable range is
± 10 dB (knob turned in the direction of clockwise) and - 10
decibels (knob turned anticlockwise).
④ BALANCE
This command allows you to adjust the relative output levels of
the left and right channels. In the center position, the output
level of each channel is equal.
⑤ DIRECT
If this function is activated (light signal active), then the BASS
and TREBLE functions are disabled. The purpose of this function
is to shut down the electronic circuit’s tone control in order to
best preserve the purity of the music signal.
⑥ VOLUME
This knob adjusts the output volume of the amplifier at the
speaker outputs.
⑦ LOUDNESS
Musical recordings are made with devices that are designed to
keep the musical balance as at a concert. When reproducing the
same quality is desired by the listener. This is the entire chain,
from microphone to the listener’s ears to be faithful.
The Loudness function object to «compensate» the peculiarity
of the human ear. Thus, we invite you to «activate» the button
when you listen at low volume.
Connections and uses
