11. Connect the power and data cables
.
.
13.
Slide the server into the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
The installation is complete.
Installing a midplane 4LFF SAS/SATA drive cage
Observe the following:
• A 1U heatsink is required for each processor when installing this option.
• If you have a TPM, install it prior to this option.
• If you have a type-a controller, install it prior to this option.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
Procedure
1.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack
•
Remove the server from the rack
.
4.
.
5.
.
The air baffle is no longer needed. The drive cage acts as an air baffle for the server.
Installing a midplane 4LFF SAS/SATA drive cage
75
Summary of Contents for BCD221
