Front Gable End Assembly
Lay out the front pieces into the shape of an end wall. The doorframe and all glass bars have a track
for the bolts. The track must face up towards you when you assemble the gable ends. Slide the bolts
in to the ends or use the notches that are punched out in the glass bars. Refer to the line/detail
drawings when assembling. (
the sketches/drawings/pictures are viewed from inside the greenhouse).
– 8 –
T R A D I T I O N A L S E R I E S S T R A I G H T M O D E L • G R E E N H O U S E I N S T R U C T I O N S
1.
Bolt the bottom plates (4 holes)
to the base/sill and the doorframe
sides using 1/4” x 1/2” stainless
steel bolts
(see Pic A).
Before
tightening the bolts, be sure that
it is square.
(If you ordered a
greenhouse with a door drop,
measure from the bottom of the
doorframe to the underside of the
base according to the specified
distance.)
2.
At the top of the doorframe, put
on the doorframe header (which
looks the same as the side pieces).
Put the header
between
the two
side pieces and bolt on the plates
(6 holes).
(See Pic B.)
The plates
should stick up 1” above the
doorframe. Note how the plates
are put on. Before tightening the
bolts, be sure to square up the
doorframe.
3.
Take the corner post (angle cut on
top) and bolt it to the base.
(See Pics C and D.)
Base
Side Door
Frame
Top
Side
End Rafter
Corner
Post
Corner
Post
Base
A
B
C
D
