April 2019
– Issue 4
Page
12
of
48
Section 3 - Operating Guide (continued)
3C.2 - Headlight & direction indicator control stalk
(figure 7):
This is located on the left side of the steering column.
Figure 7
OFF
Both high beam headlight and side lights are turned off.
This is the vehicle marker lights. Rotate the handle clockwise to the sign position, all the side lights, instrument
lamp and outline marker lamps turn on.
This is the headlights. Rotate the stalk continuously clockwise to the sign position, the headlights, the marker lights,
the instrument lamps turn on. To change over to the high beam and low beam lamps: push the stalk down, then
the low beam lamp will turn on; pull the stalk back to normal (middle) position and the high beam lamp will turn on.
Pull the stalk upwards, move up and down and the lights will flash, in this position the stalk is spring loaded and will
return to normal position when released.
This is the turn signal indicator sign. Move the lever away to engage right turn signal; move the lever closer to
engage left turn signal.
(Red button
）
Hazard indicator switch: Push the red button on the end of the indicator stalk, switch to turn the
hazards on and off.
3C.3 - Windscreen wiper & retarder stalk
(figure 8):
1) The windscreen wiper and the retarder operating stalk is located
on the right side of the steering wheel.
2) Rotate the stalk to operate the wiper:
OFF: Stop wiping
INT: Intermittent wiping
LO: Wiping at a low speed
HI: Wiping at a high speed
Figure 8
3) To spray water on the screen, press the end of the stalk inwards, the wipers will automatically start in the low speed and
will automatically turn off a few seconds after the button is released.
4)
The retarder has three positions:
0= Off
、
1= 33%
、
2= 66%
、
3= 100%.
This control will only work if the power switch is in the ‘ON’ position
Owner’s Manual
