April 2019
– Issue 4
Page
31
of
48
Section 5 - General Maintenance (continued)
5H - Changing the air filter
(figures 31a to 31m):
5H.1
– The filter sensor will turn on the indicator mounted on the driver’s dash, which indicates when the element needs
changing.
Note: the sensor will automatically reset when the new filter/s are installed
Figure 31a
Figure 31b
5H.2
- Lift the lever on the filter cover (figure 31c) and twist cover to the left into the open position (figures 31d & e).
Figure 31c
Figure 31d
Figure 31e
5H.3
– Remove the filter cover (figure 31f) and twist the end of the filter to disengage seal (figure 31g). Gently remove the
filter element1 from the housing. Inspect the filter for foreign material on the sealing surface and potential marks of dust on
the clean air side. Note: If servicing a system that contains a secondary element, apply the same procedure.
Figure 31f
Figure 31g
5H.4
- Thoroughly clean the sealing surface and the inside of the filter housing (figure 31h). Inspect the new filter element for
damage, and if acceptable insert into the housing (figure 31j). Note: If servicing a system that contains a secondary element,
apply the same procedure.
.
Figure 31h
Figure 31j
Owner’s Manual
