October 2020 – issue 1
Page
15
of
29
Section 3 - Operating Guide (continued)
ZERO EMISSION CITY BUS Owner’s
Manual
3C.7. - Driver’s side console
(figure 12):
1) Rearview mirror toggle
2) Park brake
3) Master power switch
4) Charge mode switch
5) Emergency override switch - door
6) USB
Figure 12
1
2
3
4
5
6
Driver’s side console controls:
3C.8.1
Toggle for rearview mirrors:
Toggle left or right to adjust either nearside or offside mirror position
3C.8.2 - Park Brake Control
(figure 13):
The Park Brake control is located within easy reach on the driver’s side console.
3C8.2.1 To release the park brake
, lift the round collar and move the lever forward (both
are spring loaded).
3C8.2.2 To apply the park brake
, pull the lever back until it locks into position (if the lever
springs forward it is not locked in position and the brakes are not applied). Try
again until the lever is locked in the rear position.
Figure 13
3C.8.3
Charge mode switch:
Activate this switch to invoke charge mode and enable recharging of the main Energy Storage System
(propulsion system batteries) via the CCS2 charging socket at the rear of the bus. While charge mode
is active driving of the bus is disabled.
Note:
white dash will alight when switch is active
3C.8.4
Master power switch:
Push up sliding lock and press down to isolate all vehicle electrics.
3C.8.5
Passenger door – emergency override button:
Press to release door.
3C.8.6
USB Port:
For electrical items requiring a USB connection
