NX260N
14
1.4 System Memory
1.4.1
DIMM Sockets Location
The motherboard comes with
two
200-pin Double Data Rate 3 (DDR3) SODIMM sockets.
A DDR3 module has the same physical dimensions as a DDR2 DIMM but has a 204-pin
footprint compared to the 200-pin DDR DIMM. DDR3 DIMMs are notched differently to
prevent installation on a DDR2 DIMM socket. The following figure illustrates the location of
the sockets:
1.4.2 Memory
Configurations
You can install 1GB and 2GB DDR3 SDRAM DIMMs into the SODIMM sockets using the
memory configurations in this section.
Installing DDR3 DIMM other than the recommended
configurations may cause memory sizing error or system boot
failure. Use any of the recommended configurations.
Due to chipset graphic resource allocation, the system may
detect less than 2 GB system memory when you installed one 2
GB DDR3 memory modules.
This motherboard does not support memory modules FSB less
than 1066MHz.Make sure that the memory frequency matches
the CPU FSB (Front Side Bus). Refer to the Memory
frequency/CPU FSB synchronization table.
