3 October 2016
# 1050301D 1998.5-2002 Dodge Cummins FlowMAX Lift Pump Kit
(I-00167)
- 7 -
BD Engine Brake Inc.
Plant Address: 33541 MacLure Rd. Abbotsford, BC, Canada V2S 7W2
U.S. Shipping Address: 88-446 Harrison St, Sumas, WA 98295 U.S. Mailing Address: P.O. Box 231, Sumas, WA 98295
Phone: 604-853-6096 | Fax: 604-853-8749 | Internet: www.bd-power.com
6. Locate the two supplied T Bolt
band clamps; unthread the nut
(7/16” Socket) from each of
them. Spread the clamps apart
and insert them through boxed
cutouts.
With both clamps inserted, place
the pump into place and align the
inlet and outlet parallel to the
frame.
The
inlet
should be pointed
towards the fuel tank.
Tighten the clamps around the
motor body, rather than the
aluminum pump head. Torque
nuts to
80 in-lbs.
7. Insert the Filter fitting (1500311-M)
into the (IN) side of the pump and
the ORB fitting (1500311) into the
outlet of the pump. Do not over
tighten as they use an o-ring for
sealing.
NOTE: If installing a filter kit, skip this
step and refer to the Flomax Filter Kit
manual for the install procedure for the
water separator and fuel filter. Once
Filter install is complete; continue to
step 8.
FITTING
FITTING
