BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 2133
Battery-, charging- and
starting system analyzer & printer
TECHNICAL DATA
Test range: 40 - 2000 CCA (SAE)
Voltmeter: 1.5 - 30 Volt
Accuracy: Voltage 0.1V / CCA 5% / IR 5%
Operating temperature: 0°C-50°C (32°F-122°F)
Batterie test 6V / 12V
Starting / Charging system test 12V / 24V
Measure battery internal resistor IR
Multi-standard test: SAE, DIN, EN, IEC, CA, JIS
Display: LCD 66 x 33 mm
Thermal printer with 58 mm x 10 m paper roll
Battery type: 6x 1.5V AA
Languages: English, Francais, Deutsch,
Espanol, Portugues
INDENDED USE
This product is used to check 6V and 12V batteries and to test 12V and 24V starting and charging
systems. The product is suitable for standard tests SAE, DIN, EN, IEC, CA and JIS.
SAFTY INFORMATIONS
Before using the product, please read the instructions and the included safety information carefully.
Observe operating environment temperature of 0°C-50°C (32°F-122°F).
Keep good ventilation around the surroundings tested battery.
Do not expose the instrument to direct use when it rains or snowy days.
Please wear protection and safety equipment.
Do not place metal objects near or touch the battery, including googles, watches and other
items.
Do not smoke around the battery.
Only use distilled water to refill the battery.
When disconnecting the battery from system, make sure all electrical devices like radio,
amplifiers, etc. are switched off.
When take out the battery from car, make sure all battery caps had been closed.
Do not use damaged batteries and clean the battery terminals.
lf the battery acid run into eyes, please rinse eyes with many fresh water. Ask a doctor for
advice.
Do not perform battery tests on batteries with more than 12 volts.
Do not perform starting or charging system tests on systems with more than 24 volts
.
COMPONENTS
1
Thermal printer
2
LCD Display
3
Forward button
4
Back button
5
Enter button
6
Red battery clamp (battery minus -)
7
Black battery clamp (battery plus +)
