50
Using
AkkuMAB 3000
ENGLISH
Drilling with the machine
Drilling with core drills
When drilling with core drills, proceed as follows:
Insert the ejector pin (C) into the core drill.
Insert the core drill with the ejector pin as described in chapter
Inserting the tool
.
Place the machine at the working location, align it and switch
on the magnetic clamps.
Switch the machine on.
Direct the drill with the handle (9) to the material.
NOTE
Observe the following instructions when drilling with core drills:
Drilling with core drills does not require great force. The drilling
►
process is not accelerated by higher pressure. The drill wears
faster and the machine can be overloaded.
Use high-performance oil in the cooling lubricant system of the
►
machine.
The cooling lubricant system cannot be used when working
►
overhead. In this case, use the high-performance ZHS 400
grease spray. Spray the drill on the inside and outside before
drilling. Repeat this procedure when drilling deeper holes.
Make sure that swarf is removed regularly. With larger drilling
►
depths, break the chip.
Summary of Contents for AkkuMAB 3000
Page 143: ......
