14
EKF Series 300/500/600
GB
Turning the reversing plates
To turn the reversing plates (20, fig. 6),
proceed as follows:
Loosen the side clamping screw (3,
fig. 4).
Unscrew the housing from the motor.
Loosen the fixing screws (21, fig. 6)
with the tools supplied in the scope
of supply, turn the reversing plate an
screw tightly.
Repeat the procedure for all reversing
plates of the miller.
Screw on the housing again.
Tight the clamping screw.
Replacing the reversing plate
When the reversing plate (20, fig. 6) is
completely worn, it must be replaced by a
new one:
Unscrew the Sie fixing screw (21,
fig. 6) with the screwdriver (Torx) and
remove the reversing plate.
Insert the reversing plate and tighten
the fastening screws again.
Tool change
