7
MAB 455
GB
WARNING
►
Always switch off the machine before
changing tools, performing main-
tenance or cleaning. Wait until the
machine has come to a complete
standstill.
►
Always remove the plug from the
mains socket before changing tools,
cleaning or performing maintenance
work in order to avoid unintentional
starting of the machine.
►
Do not put your hand into the ma-
chine while it is in operation. Remove
swarf only when the machine is at
a standstill. Wear protective gloves
when removing swarf.
►
When working on scaffolding, the op
-
erator must be secured with a safety
belt as the machine can oscillate dan-
gerously in the event of interruption to
the power supply.
►
Check for secure clamping of the
electromagnets on the substrate be-
fore every use (see section
“Prepa-
ration”
).
►
Secure the machine with the safety
chain (D) supplied when working in
an inclined or vertical position and
during overhead work. The machine
could fall down if the magnet is loos-
ened or the power fails.
►
Check that the tool is tightened
securely before using (see section
“Inserting the tool”
).
►
Do not allow the connecting cable to
hang over edges (trip effect).
Preventing damage
ATTENTION
Potential damage to property if the
machine is improperly used!
Observe the following instructions to
avoid damage to property:
►
Before connecting the machine, com-
pare the connection data (voltage and
frequency) on the rating plate with
those of your mains power supply.
The data must correspond in order to
avoid damage to the machine.
►
Always use the handle to carry the
machine and not the connecting
cable.
►
Do not pull the mains cable to remove
the plug from the mains socket.
Safety
