4
USER MANUAL
MAINTENANCE
NOTICE:
Use high grade hydraulic oil only. Never use brake fluid, motor oil, transmission fluid, turbine oil or any other fluids.
ISO-VG22 or equivalent hydraulic oil is recommended.
CHECK AND REFILL OIL
LUBRICATION AND CLEANING
AIR VENTING PROCEDURES
DAMAGED EQUIPMENT
Any jack that appears to be damaged in any way, is found to be worn, or operates abnormally
SHALL BE
REMOVED FROM SERVICE UNTIL REPAIRED
. It is recommended that necessary repairs be made by a
manufacturer’s or supplier’s authorized repair facility if repairs are permitted by the manufacturer or supplier.
ALTERATIONS
Because of potential hazards associated with this type of equipment, no alterations shall be made to the
product.
ATTACHMENTS AND ADAPTERS
Only a attachments and/or adapters supplied by the manufacturer shall be used.
• With the jack in the fully lowered, level position remove the oil filler screw.
• Proper oil level should be even with the bottom of the oil filling hole.
• Do not overfill. Always fill with new, clean hydraulic jack oil as recommended above.
• Reinstall oil filler screw, and then reinstall unit cover.
Full replacement of oil is recommended every year for maximum life. To completely drain oil out
of the system, follow step one above and then lay the jack on its side allowing the oil to drain into
an appropriate container. Once completed, refill the oil reservoir as indicated in step two. Properly
dispose of used oil.
• Periodically clean and lubricate all moving parts and pivot points. A periodic light coating of
lubricant to all moving parts will help prevent the development of rust.
• Remove cover.
• With the jack in the fully lowered position, release valve open, remove oil filler screw.
• Activate the control valve for 5 – 7 seconds to help purge trapped air. Reinstall oil filler screw.
• Proper oil level should be even with the bottom of the oil filling hole.
