11
Use extreme caution unpacking this machine. Some components are very heavy and will require additional people
or mechanical handling equipment.
NOTE:
All references in this manual to the left or right side and front or back of the log splitter are from the
operating position only. Exceptions, if any, will be specified.
Unpacking tools needed:
1. Wrench 13mm
2. Scissors or knife
3. Pry bar or claw hammer
Step 1:
Use a 13mm wrench to remove the bottom bolts and washers securing the crate side frames onto the
crate bottom, and then lift up and put away the crate top and the cardboard box. See FIGURE 3.
Page | 11
\UNPACKING
This product has been shipped pre-assembled (see
FIGURE 3
)
.
•
Carefully remove the log splitter and all accessories from the box. Make sure that all items listed in the
packing list are included
.
•
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
•
Do not discard packing materials until you have carefully inspected and satisfactorily operated the tool.
•
If any parts are damaged or missing, please call 1-800-780-2677 for assistance.
•
Screw on the control handle lever before operation (see
FIGURE 3
).
WARNING:
If any parts are damaged or missing, do not operate this tool until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or
modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and
possible serious personal injury.
UNPACKING & ASSEMBLY
(FIGURE 3).
Page
│
11
UNPACKING THE CONTAINER
ASSEMBLY & SET-UP INSTRUCTIONS
Page 8
WARNING!
Use extreme caution unpacking this machine. Some components are very heavy and will require
additional people or mechanical handling equipment.
NOTE:
All references in this manual to the left or right side and front or back of the log splitter are from the operating
position only. Exceptions, if any, will be specified.
Unpacking tools needed:
1. Wrench 13mm
2. Scissors or knife
3. Pry bar or claw hammer
Step 1:
Use a 13mm wrench to remove the bottom bolts and washers securing the crate side frames onto the crate
bottom, and then lift up and put away the crate top and the cardboard box. See FIGURE 3.
UNPACKING THE CONTAINER
ASSEMBLY & SET-UP INSTRUCTIONS
Crate Top
Crate Side
Frame
Flat Washer x 24PCS
Hex head bolt x 24PCS
Crate Bottom
(FIGURE 3)
Page 11
