SMART SAFE 3001D-1GL/3GL/5GL
SMART SAFE 3001D 1GL/3GL/5GL
25
URGENCY
OPEN WITH IB KEY
If you forgot the code, you can open the smart safe by opening IB key. For the opining procedure proceed as
follows.
OPEN WITH MECHANICAL KEY
While the code has been forgotten or all the opening IB keys were lost, you can open the smart safe by the
mechanical key.
The mechanical keyhole is concealed inside the LCD display. Push the screen to the left and then
you will see the keyhole.
Insert the mechanical key and screw clockwise to open the smart safe.
LOW-VOLTAGE ALARM
If the smart safe emits 8 beeps for warning, it means that the batteries are almost running out, the smart safe
can be still opened for 100 times. The batteries need to be replaced.
In order to do so, remove the protective lid unscrewing the screw and replace the run out batteries with the
new one.
NOTICE
Make sure that the batteries are used the battery type of alkaline 1.5 Volt.
TROUBLESHOOTING
ERROR ALARM
When you key in the wrong code, after the third attempt, the smart safe will let out an acoustic alarm signal
lasting sixty seconds, you can stop the warning by touching any opening IB key on the IB receiver, or you can
wait after sixty seconds, the smart safe will be used again.
OPENING KEY FAILS TO OPEN SMART SAFE
Make sure that the key is the owner key, not the time card or the audit trail card.
Make sure that the owner key has been assigned by the DS1990 type.
Make sure that the owner key is putting against the receiver.
Make sure that the owner key has been assigned, if not, you should follow the procedures to
assign an owner key,
One beep
Touch an opening key
on the receiver
The door will open
automatically
