18
DECT Setup
You can choose the following options for your DECT:
Intercom:
More than 2 handsets register to the same base, enter the submenu of intercom, press
OK
key, the handset will ring, then press
Talk
to begin intercom.
(Power) On:
Press
OK
to switch the DECT mode
On
.
(Power) Off:
Press
OK
to switch the DECT mode
Off
.
BS Setting:
Here you can choose the following options:
Del Handset:
Log out the handset.
Flash time:
For operation on a PABX, you may have to change this value. Please refer
to the user guide of your current DECT station for your PABX. You can
choose the following flash times:
100ms, 300ms, 600ms
and
1000ms
.
Dial mode:
The following dialling modes can be selected:
Tone
or
Pulse
.
Change PIN:
Here you can change the base station PIN (default: 0000).
Base default:
Input the PIN code (0000) to reset the settings.
HS Setting:
Here you can choose the following options:
Select Base:
You can register up to four base stations on your handset.
HS Name:
The handset name can be changed (maximum 30 characters).
Registration:
Connect the base station:
Position the base station within reach of the telephone line socket and a power socket.
For safety reasons, only use the power adapter plug supplied.
1.
Connect the base to the power socket. Plug the connector at one end of the power
cable in the socket marked on the rear side of the base station and the power adapter
plug in a properly installed 230 Volt power socket. The power adapter plug from the
base station must remain connected at all times.
2.
Connect the base with the phone line socket. Connect the one end of the telephone
connection cable enclosed to the telephone line socket and the other end to the
telephone jack on the rear side of the base station. Only use the telephone
connection cable supplied.
Please follow the instructions step by step for a correct registration of your S700 on the
DECT base station:
1.
Long press the Base station key (10 sec.), registering LED of base will flash.
