19
2.
Go to
DECT setup
,
choose (Power)
On
and press
OK
.
3.
Go to
Registration
and press
OK
.
4.
Choose the base (1-4) and input the PIN code (default: 0000) and press
OK
.
5.
There will be a popup message asking whether to register cordless phone.
6.
Press
Yes
to start, after a few seconds the handset is registry on the base station.
7.
The S700 is now registered and can now be used for phone calls.
Note: If you leave the reception area of the DECT base station with the S700 for longer than 5
minutes, the DECT mode on the S700 automatically closes down. Should the S700 re-enter the
reception area, you can go back to DECT mode by holding the up arrow key pressed in the standby
mode. The DECT mode is turned on again.
Troubleshooting
:
If you have problems with your telephone, please check the following points first:
Can’t make a call:
The telephone line is not correctly connected or is faulty. Use only the telephone cable
provided.
Test whether your telephone connection is in order by using another telephone. The
power supply is not plugged in or there is a total power failure.
The rechargeable batteries are flat or defective.
You are too far away from the base station.
U don’t have a DECT subscription.
Connection is cut off or drops out:
You are too far away from the base station or the base station is wrongly positioned.
No selection possible:
Wrong selection set.
The system stops responding or is in an undefined state:
Reset all functions to their default settings. Before doing this, please remove the
adapter out of the socket.
Bluetooth
You can connect wirelessly to other Bluetooth compatible devices such as headsets.
In standby mode:
press the Bluetooth button on the side to switch Bluetooth
On
or
Off
.
You can choose the following options:
Power:
Here you can choose to turn
Bluetooth On
or
Off
.
Inquiry audio device:
Search for available Bluetooth audio devices. If Bluetooth is not
enabled you can enable it now by pressing
Yes
.
My device:
List of saved devices and enables you to add new devices;
Inquiry
new device
.
Inquiry new device:
1.
Press
OK
, the phone is going to search for new devices.
