Battery Install
Remote Control
Your remote control handset is powered by two (2) AAA type batteries
•
Effective remote range is approximately 16 feet at an
angle of no greater than 30° to the left / right or 20° up /
down to the IR sensor.
•
To avoid possible damage from battery chemical
leakage, remove the batteries if you do not plan to use
the remote for an extended period of time. Do not mix
batteries of different age and / or type. Always discard
used batteries safely.
•
Do not expose the remote control to liquids, direct sun-
light or sources of excessive heat.
•
The IR receiver on the TV will not work properly if the set
is in direct sunlight.
NOTE: Improper use of batteries can result in a chemical
leakage or explosion.
Comcast or Direct TV : 10030, 12731
Dish Network : 506
RCA Universal : 0030
Cable / Satellite Remote Control Codes:
NOTE:
The remote control from your Cable/Satellite provider can be programmed to operate most
of the major functions of this TV model which include:
POWER, INPUT / SOURCE, ,
VOLUME - , C, CHANNEL - , SELECT/OK/ENTER
(based on your remote), and
NUMBER
buttons. For non-major TV functions not listed, use the remote control included with this TV.
T
o program your Cable / Satellite remote to operate this TV, follow the programming instructions
included with your providers’ remote and use the following codes.
• Turn the remote over and remove
battery cover.
• Place two (2) “AAA” batteries into
the battery compartment with the “+”
and “-“ ends facing as indicated.
• Replace the cover
AT & T (U-verse) : 1043
8
30
30
IR Receiver
Cox: 2397, 2049, 10030, 12731
