EN - 11
Device-specific additional instructions for nailer
PC-340C
4
Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Turn the tool upside down, press the lock 1 and pull the lower
slide 2 backwards. Release the locking button 1, insert the
clamps 3 into the magazine. Then push the lower slide forward
again.
5
Inserting plastic caps
•
Pull red feeder to the top, turn and lock.
•
Press lever 2 and open cover 3.
•
Insert plastic caps 4 into the magazine from the top. Firmly hold
upper disc with the other hand and pull off wire 5. Afterwards close
cover 3 and release feeder 1.
6
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
-----------------------------------------------------------
Dr. Jörg Dalhöfer, CEO
Joachim Bauer, Documentation responsible
Summary of Contents for PC-340C
Page 7: ...7 ...