Beachcomber Hybrid4, Tech Book

2

6

Spa Transmitter (CO Module) LED status

This module’s LED can show various status conditions, as shown below

�

Troubleshooting

Rapidly flashing YELLOW color :

The Spa Transmitter is in pairing mode when this color is 
s

hown� This norm

ally briefly occurs automatically during 

power-up of the hot tub

 (i�e� r

ight after the breaker is 

flipped 

on)� This could also occu

r if the Spa Transmitter 

was never paired (which is very unlikely, as they are 
shipped paired fro

m factory)� Refer

 to the pairing section 

if your unit has not been paired, so you may complete 
the 

process�

BLUE color :

Reason?

This is the normal state of the Spa Transmitter

 LED�

 If the Spa Transmitter also shows solid blue, you are all 
set! If this LED is blinking, refer to the Blinking LED  
s

ection below�

What to do?

Enjoy your hot tub!

Blinking LED :

On both modules, if the LED is blinking about once per 
second, it means that the RF link is not established 
between them (i

�

e

�

 each in

�

touch 2 module cannot 

communicate with its counterpart)

�

 This can occur for 

several reasons

�

Review the following and perform the tests in the order 
given below

�

Unpaired:

As the modules are shipped paired from the factory, this is 
not a likely cause, but it is the easiest test to perform in the 
field

�

 Simply attempt to pair them again

�

 Please refer to the 

Pairing section for instructions on pairing

�

Modules out of range:

If the pairing test above does not resolve the problem, 
then the modules may be too far from each other for an 
effective RF link

�

 To test this, simply connect the Home 

Transmitter outside, close to the spa (via an extension 
cord for power)

�

A router connection is not needed for this test

�

 If the 

module LEDs no longer blink, an RF link was established 
which confirms the hypothesis that the modules were too 
far apart

�

 Getting the modules closer together somehow is 

the only solution

�

If moving the modules closer together does not stop the 
LEDs from blinking, attempt to pair them again

�

 If this 

pairing fails even though the RF modules are near each 
other, then one or both of the modules are defective, 
replace them

�

T of C