AIRFUSION MOTO Installation Instructions
4 |
P a g e
INSTALLATION OF THE FAN
INSTALLATION OF BLADE (Fig. 8)
1.
Before Installing the blades, remove the blade screws from the top of the fan motor assembly.
2.
Align the 2 holes on the blade with the 2 holes on the rotating member of the fan motor assembly.
3.
Use the 2 blade screws from step 1, to secure the blade onto the fan motor assembly.
Ensure all screws are tightened evenly to reduce the chance of warping or unbalancing. Take care not to
over tighten the screws, as this can damage the blades.
4.
Repeat the same process for the other blades.
INSTALLATION OF BOTTOM COVER (Fig. 9)
•
Install the bottom cover to the fan assembly then secure it by turning clockwise.
⚫
Complete the electrical wiring according to the ‘ELECTRICAL WIRING DIAGRAM’ section below. (Fig.10)
Noted:
The MOTO fan is a DC technology fan and cannot be used with an AC wall switch. If use wall
switch, on/off toggle wall switch – only, Always leave in the “on” position and use remote.
Fig.8
Fig. 9
