Page 1-132
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Local Alarm Power-Up
Chapter 1: Introduction
Local Alarm Power-Up
Tools required:
Phillips head screwdriver
1. Using a phillips head screwdriver, loosen the four screws (DI) enough to
allow the front panel (DJ) to slide off (see figure 1-68 on page 1–132).
Figure 1-68. Local Alarm
2. Slide the front panel (DJ) off of the back box (DL).
3. Turn the power switch (DK) to the ON position.
NOTE:
The Local Alarm lights either a green normal LED or a red alarm LED for each
of its 16 inputs. If there is an alarm condition upon power-up, the alarm sounds.
4. If the Local Alarm is functioning properly, secure the front panel (DJ) to the
back box (DL).
Summary of Contents for MedPlus TotalAlert
