2.10 Area Alarm Module ROM Error
1. An Area Alarm Module displays error code
A 05
.
Yes
No
L J
Go to “Final Actions” on page 2-7.
2. Area Alarm Module is connected properly.
Yes
No
L J
Connect the Area Alarm Module properly (refer to procedure
4.9 on page 4-26). If this solves the problem, go to “Final
Actions” on page 2-7. Otherwise, go to step 3.
3. Area Alarm Module is working correctly.
Yes
No
L J
Replace the Area Alarm Module (refer to procedure 4.9 on page
4-26). If this solves the problem, go to “Final Actions” on page
2-7. Otherwise, go to step 4.
4. If the problem still exists, call BeaconMedæs Technical Support.
2.11 Battery Low on Master Alarm
1. Battery Low
displays on the Master Alarm.
Yes
No
L J
Go to “Final Actions” on page 2-7.
2. Check the Master Alarm’s battery voltage. It is approximately 2.9 V DC.
Yes
No
L J
Replace the Master Alarm’s battery (refer to procedure 4.3 on
page 4-12). If this solves the problem, go to “Final Actions” on
page 2-7. Otherwise, go to step 3.
3. If the problem still exists, call BeaconMedæs Technical Support.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Page 2-19
Area Alarm Module ROM Error
Chapter 2: Troubleshooting Procedures
2
Summary of Contents for MedPlus TotalAlert
