Page 1-14
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Features
Chapter 1: Introduction
When installing the MedPlus TotalAlert® Alarm Network Conversion Kit, the
Breakout P.C. Board and the power supply assembly mount in the existing
alarm’s rough-in box. The conversion kit power supply mounts as single sub-
assembly, but uses the same internal components as the original power supply.
For more information about installing a conversion kit, refer to the
MedPlus
TotalAlert® Alarm Network Conversion Kits Installation Instructions
.
Master Alarm Front Panel
The Master Alarm Front Panel is designed to swing open from the rough-in
assembly (E) to easily install and service the alarm. The front panel consists of
the following (see figure 1-5 on page 1–14):
• Faceplate (M)
• Hinged door (L)
• Master Alarm Module (J)
• Lock (K)
Figure 1-5. Master Alarm Front Panel
Summary of Contents for MedPlus TotalAlert
