Page 6-20
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Setting up the Internet Interface
Chapter 6: General Procedures
NULL Modem Driver Setup Instructions for Windows® Operating
System
If using an RS-232 serial port, you have to set up a NULL modem driver that
allows your computer access to the alarm’s Web pages without having a real
modem connected.
To set up the NULL modem driver, do the following:
1. Click on
Start
.
2. Go to
Settings
.
3. Click on
Control Panel
.
4. Double click on
Modems
.
5. Click on
Add
, unless you don’t have any existing modems; then check the
“
Don’t detect my modem; I will select it from a list
.”
6. Click on
Other
.
7. Click on
Next
.
8. Check the
Don\qt detect my modem
box.
9. Click on
Next
.
10. Click on
Have Disk
....
11. Locate the file Mdmcisc2.inf.
12. Click on
Next
.
13. Select
Generic NULL Modem
from the list.
14. Select the serial port on your computer that you want to use.
15. Click on
Next
.
16. Click on
Finish
.
Summary of Contents for MedPlus TotalAlert
