Page 6-22
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Setting up the Internet Interface
Chapter 6: General Procedures
b. Select
PPP:Internet
,
Windows® NT Server
,
Windows® 98
for the
Type of Dial-Up Server
on the
Server Types
tab.
NOTE:
Windows® Me and Windows® 2000 work the same way.
c. Check
Log on to network
.
d. Check
Enable software compression
in the
Advanced Options
.
e. Click on
TCP/IP Settings
in the
Allowed Network Protocols
.
NOTE:
Have only
TCP/IP
checked.
f.
Click on
Specify an IP address
and enter
192.168.1.100
.
This is the serial port address that your PC uses as a server.
g. Check
Server assigned name server address should be checked
.
h. Check
Use IP header compression
.
i.
Remove check from the
Use default gateway on remote network
box.
j.
Click on
OK
.
k. Click on
OK
.
Serial Port (PPP) Connection
1. Double click on the dial-up connection.
2. Click on
Connect
.
NOTE:
No Password is required.
3. When two little monitors are on the task bar, the connection is established;
click
Close
.
Summary of Contents for MedPlus TotalAlert
