d. If there is more than one system for a particular source, record their sys-
tem numbers.
e. Record the message that you want displayed when an alarm occurs. If
programming from the front panel, you must use the messages on table 1-
28 on page 1-57.
NOTE:
These are pre-set messages you can use when configuring the Master Alarm
either by using the front panel or the Web pages. If the you choose to configure
the Master Alarm by using the Web pages, you have the option of customizing
messages.
Table 1-28. Master Alarm Messages
a. Cylinder reserve less than (1) hour supply.
For WAGD, Medical
Vacuum, Lab Vacuum,
Dental Vacuum
For Helium, Oxygen,
Nitrogen, Nitrous Oxide,
Carbon Dioxide,
Oxygen/Carbon Dioxide
Mix, Argon
For Medical Air, Lab Air,
Dental Air, Instrument Air
Thermal Shutdown
Liquid Level Low
Dryer Malfunction
Backup Vac Pump On
2nd Supply in Use
Dew Point High
Low Vacuum
Rsrv. Supply in Use
Carbon Monoxide High
Low Water
Reserve Supply Low
Change Filter
System Malfunction
High Line Pressure
Receiver Water High
Service Required
Low Line Pressure
Separator Water High
Custom Message
Reserve Pressure Low
Air Disch. Temp High
Main Supply Level Low
Backup Compressor On
Custom Message
Compressor Malfunc.
Thermal Shutdown
High Line Pressure
Low Line Pressure
Reserve Pressure Low
2nd Supply in Use
Reserve Supply in Use
Reserve Supply Lowa
System Malfunction
Service Required
Custom Message
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Page 1-57
Master Alarm Labeling
Chapter 1: Introduction
1
Summary of Contents for MedPlus TotalAlert
