Returning to Normal Operating Mode
To return to normal operating mode and
save
any changes that you have made at
any time, do one of the following:
•
Press the configuration button (CD) (see figure 1-20 on page 1–64).
•
Turn the power supply switch (DQ) to the OFF position and then back
to the ON position (see figure 1-19 on page 1–63).
If you do not press any keys for 10 minutes, the alarm returns to normal opera-
tion and saves any changes that you have made.
While in the configuration mode, the front panel keys operate differently than
they do in normal operation mode (see figure 1-21 on page 1–65 and table 1-29
on page 1-66).
Figure 1-21. Master Alarm Front Panel
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Page 1-65
Configuring the Master Alarm Using the Front Panel
Chapter 1: Introduction
1
Summary of Contents for MedPlus TotalAlert
